Sharp UX-CD600 - Manual (Page 38)

Line Settings
36
Specifying how the line is selected (dialing line setting)
If you have connected two lines to the machine, use this setting to specify how
the line is selected when you make a phone call or send a fax by manual
dialing. The settings are MANUAL and AUTO. When MANUAL is selected,
you must manually select the line each time you make a phone call. When
AUTO is selected, the machine will automatically select an open line.
The machine is initially set to MANUAL. If you wish to change the setting to
AUTO, follow the steps below.
Note: The dialing line setting does not apply to faxes sent by automatic dialing
(see page 88). When you send a fax by automatic dialing, the machine will
normally use line 2. The machine will only use line 1 if line 2 is busy.
1
Press once and once on
the machine.
2
Press once and twice.
3
Press once.
4
Press to select AUTO (the
machine will automatically select the
line), or to select MANUAL (you
must select the line each time you
dial).
5
Press to return to the date and time display.
FUNCTION
STOP
Display:
OPTION SETTING
DIALING LINE
DIALING LINE
1=AUTO, 2=MANUAL
The display briefly shows
your selection, then:
LINE 2 INVALID
all.book 36 ページ ２００４年６月２２日 火曜日 午後１２時１分