Sharp UX-CD600 - Manual (Page 76)

Transfer Function
74
Recording the transfer message
The transfer message plays when you answer the telephone, and informs you
that the call is a transfer call. The following is an example:
“Hello. This is a transfer call for (YOUR NAME). Enter your remote code
number now.”
1
Press once and twice.
2
Press once.
3
Press and speak facing “MIC” on the operation panel to
record the message.
•
The transfer message can be up to 15 seconds long. While recording, the
display will show the time left to record.
4
When finished, press .
REC/
MEMO
START/MEMORY
STOP
Display:
Checking or erasing the transfer message
To check or erase the transfer message, follow Steps 1 and 2 of the above
procedure, and then press to check the message, or to erase
the message.
Turning the Transfer function on and off
When you go out and wish to use the Transfer function, turn it on as follows:
PLAY/
HOLD
DELETE
FEB-20 10:30
OGM (TRANSFER)
FEB-20 10:30
START: RECORD
6
Press to return to the date and time display.
STOP
all.book 74 ページ ２００４年６月２２日 火曜日 午後１２時１分