Sharp UX-CD600 - Manual (Page 65)

Setting a Passcode for a Personal Box
63
3. Ans
w
er
ing
System
3
Press once.
4
Press and speak facing “MIC” on the operation panel to
record the message.
•
While recording, the display will show the time left to record.
5
When finished, press .
START/MEMORY
STOP
FEB-20 10:30
START: RECORD
To delete or check an outgoing message
To delete or check an outgoing message, follow Steps 1 through 3 of the
above procedure to select the message, and then press to delete or
to check. Note that the general outgoing message cannot be deleted.
If you need to change it, simply repeat the recording procedure.
Note: If a passcode has been set for a personal box as explained below,
deleting the OGM of the personal box will also clear its passcode.
Setting a Passcode for a Personal Box
You can set a 3-digit passcode for each personal box. When this is done, the
passcode must be entered to listen to messages in a personal box at the
machine. (Note: When listening to the messages in a personal box from its
corresponding cordless handset, it is not necessary to enter the passcode. )
♦
An outgoing message must be recorded for a personal box before a
passcode can be set.
DELETE
PLAY/
HOLD
1
Press once and once.
2
Press once and once.
FUNCTION
Display:
T.A.D. SETTING
BOX PASSCODE
all.book 63 ページ ２００４年６月２２日 火曜日 午後１２時１分