Maintenance mode – Star Trac FITNESS S-TR User Manual
Page 45
STAR
TRAC
S
SERIES
TREADMILLS
O
WNER
’
S
M
ANUAL
45
Item
Lowest
Value
Highest
Value
Default
Value
Meaning
MNS
0.3 (mi)
0.8 (k)
2.0 (mi)
3.2 (k)
0.5 (mi)
0.8 (k)
Minimum Speed. Treadmill minimum operating speed in miles or kilometers,
based on current UNx setting.
MXS
5.0 (mi)
5.0 (k)
12.5 (mi)
20.0 (k)
5.0 (mi)
5.0 (k)
Maximum Speed. Treadmill maximum operating speed in miles or kilometers ,
based on current UNx setting.
ACC
25
60
25
Acceleration Time. Time in seconds to accelerate from current speed to a
specified higher speed.
DEC
20
60
20
Deceleration Time. Time in seconds to decelerate from current speed to a
specified lower speed.
AST
OFF
ON
OFF
Auto Stop Enable. Enables/disables Auto Stop function.
AFE
OFF
ON
ON
Auto Fan Enable. Enables/disables Auto Fan function.
PAU
30
120
60
Pause duration during a program, in seconds, either 30, 45, 60, 90 or 120.
MAINTENANCE MODE
Your Service Representative may need to check accumulated data about the past usage of your treadmill, test its display
controls, or investigate error messages. For these reasons, your treadmill is equipped with a Maintenance Mode. The
Maintenance Mode includes all of the items available through Manager Mode, plus additional items for Service and Diagnostic
use. To enter Maintenance Mode:
1. Press and hold the
,
and
keys together.
2. A beep will sound and “MAINTENANCE SETTINGS” will scroll once across the P
ROFILE
Window.
3. Release all keys. “SN” will display in the P
ROFILE
Window; the associated numeric value for the parameter will
display in the D
ISTANCE
Window.
NOTE:
The system will automatically exit MAINTENANCE SETTINGS if no key is pressed for 30 seconds.
The following keys are used to modify MANAGER SETTINGS:
Increase and Decrease Incline Keys:
Display the next (Increase) and previous (Decrease) parameters.
Keys will repeat if held.
Numeric Keypad:
Facilitates entry of the desired value for the displayed parameter. These keys do not save
the new value – see OK Key below.
OK Key:
Updates (saves) the value of the displayed parameter in Flash memory. “UPDATING” will scroll
once across the P
ROFILE
Window while the update is in process. When the update is complete, the P
ROFILE
Window will show the new value for the parameter.
NOTE:
To exit Maintenance Mode without saving any values or settings, press the S
TOP
key.
NOTE:
Unless otherwise specified, the
Item (parameter) name is shown in the P
ROFILE
Window, and the value of the
parameter is shown in the D
ISTANCE
Window.
The items that you may display and change with the previous keys are:
Item
Lowest
Value
Highest
Value
Default
Value
Meaning
SN
0
9999
N/A
Serial Number. S Series Treadmill serial number (set by factory).
DSW
1.0
99.99
N/A
Display Software. Display panel software version number (set by factory).
NOTE:
Software checksum value is displayed in C
ALORIES
Window; software
Build value is displayed in T
IME
Window
OHR
0
9999
0
Operating Hours. Total operating hours.
DST
0
9999
0
Distance. Total distance traveled in miles or kilometers, based on current UNx
setting.