Subaru 2001 Outback - Manual (Page 193)

pressing the “FOLDER” button “ ”
changes the category up by one step.
Pressing
“ ” changes the category down
by one step.
When a category is selected, pressing the
“SEEK” button selects channels only with-
in the selected category.
The control function returns to the normal
mode after approximately 10 seconds.
! Channel scan
If you press the “SCAN” button while the
radio is in the category search mode, the
radio turns to the category SCAN mode. In
the category SCAN mode, the radio scans
only channels in the selected category.
If you press the
“SCAN” button while the
radio is not in the category search mode,
the radio turns to the ALL SCAN mode. In
the ALL SCAN mode, the radio scans all
channels.
In both SCAN modes, the radio will stop at
the station for 5 seconds while displaying
the channel number, after which scanning
will continue until the entire channel has
been scanned from the low end to the high
end.
Press the
“SCAN” button again to cancel
the SCAN mode and to stop on any
displayed channel.
& Channel preset
Preset buttons
! How to preset channels
1. Press the
“SAT” button to select SAT1,
SAT2 and SAT3 reception.
2. Select the desired channel.
3. Press one of the preset buttons for
more than 1.5 seconds to store the
channel. If the button is pressed for less
than 1.5 seconds, the preceding selection
will remain in memory.
NOTE
If the connection between the radio and
battery is broken for any reason such
as vehicle maintenance or radio re-
moval, all channels stored in the preset
buttons are cleared. If this occurs, it is
necessary to reset the preset channels.
! Selecting preset channels
Presetting a channel with a preset button
allows you to select that channel in a
single operation. Up to six SAT1, SAT2
and SAT3 channels each may be preset.
Audio
5-17
– CONTINUED –