Subaru 2001 Outback - Manual (Page 283)

! To decrease the speed (by brake
pedal)
1. Depress the brake pedal to release
cruise control temporarily.
2. When the speed decreases to the
desired speed, press the
“RES/SET”
switch to the “SET” side once. Now the
desired speed is set and the vehicle will
keep running at that speed without de-
pressing the accelerator pedal.
& Cruise control indicator light
The cruise control indicator light illumi-
nates when the ignition switch is turned to
the
“ON” position and turns off after
approximately 3 seconds.
The light illuminates when the
“CRUISE”
main switch is pressed.
NOTE
. If you press the “CRUISE” main
switch button while turning the ignition
switch
“ON”, the cruise control func-
tion is deactivated and the cruise
control indicator light flashes. To re-
activate the cruise control function,
turn the ignition switch back to the
“Acc” or “LOCK” position, and then
turn it again to the
“ON” position.
. If this indicator light and the CHECK
ENGINE warning light/malfunction in-
dicator lamp flash simultaneously dur-
ing driving, have the vehicle checked
by your nearest SUBARU dealer.
& Cruise control set indicator
light
The cruise control set indicator light
illuminates when the ignition switch is
turned to the
“ON” position and turns off
after approximately 3 seconds.
The light illuminates when vehicle speed
has been set.
Starting and operating
7-41