Subaru 2001 Outback - Manual (Page 387)

prints or grease on the bulb surface,
wipe them away with a soft cloth
moistened with alcohol.
NOTE
. If headlight aiming is required, con-
sult your SUBARU dealer for proper
adjustment of the headlight aim.
. It may be difficult to replace the
bulbs. We recommend that you have
the bulbs replaced by your SUBARU
dealer if necessary.
! Low beam light bulbs
1. Pull off the fender lining. For details,
refer to
“Pulling off the fender lining” F11-
7.
2. Remove the bulb cover, by turning it
counterclockwise.
3. Disconnect the electrical connector.
4. Remove the retainer spring.
5. Replace the bulb, then set the retainer
spring securely.
6. Reconnect the electrical connector.
7. Install the bulb cover.
8. After replacing the bulb, reattach the
fender lining.
Maintenance and service
11-51
– CONTINUED –