Sharp LC-M3700 - Manual (Page 12)

11
US
Intr
oduction
Removing the battery cover
Cautions regarding remote control unit
» Do not expose the remote control unit to shock. In addition, do not
expose the remote control unit to liquids, and do not place it in an
area with high humidity.
» The remote control unit may not work properly if the remote control
sensor is under direct sunlight or strong lighting.
In such cases, change the angle of the lighting or the monitor, or
operate the remote control unit closer to the remote control sensor.
Cautions regarding batteries
Improper use of batteries can result in chemical leakage
or explosion. Be sure to follow the instructions below.
» Do not mix old and new batteries, or batteries of different
types.
» Do not charge or disassemble batteries.
» Place batteries with their terminals corresponding to the
± and — as indicated in the compartment.
» Do not short-circuit the batteries.
Caution
NOTE:
» The batteries supplied with this product may
have a shorter life expectancy due to storage
conditions. Replace with new batteries at the
earliest opportunity.
» If you will not use the remote control for a long
time, remove its batteries.
» If the remote control does not work, even with
new batteries, take the batteries out, check
whether they are facing the right way, then
replace them.
Remote control operation range
If the remote control unit does not work well:
» Objects between the remote control unit and the remote
control sensor may prevent proper operation.
» Replace the batteries when they run low as this may shorten
the remote control operation range.
10 °
10 °
6 m
7 m
6 m
Remote
control sensor
Gently hold down and
press in the arrow
direction.
Part Names – Remote Control Unit (Continued)