Sharp LC-M3700 - Manual (Page 27)

US
26
M6 30mm length
2. Attach the wall-mount bracket (with the
angle set) to the back of the Wide LCD
Monitor.
●Make sure all cables and cords are connected
and bundled (see page 29).
●Attach the terminal cover to the back of the
monitor and align the wall-mount screw holes
(Marking A: 4 locations) with the holes (4
locations) on the back of the Wide LCD Monitor.
●Use the supplied M6 30 mm length screws (4
screws) to securely fasten the wall-mount bracket
in place.
Attaching wall-mount bracket to LC-M3700 (horizontal
mount)
Mounting Options (Continued)
Mounting the Wide LCD Monitor
Wall-mount bracket
Marking A Marking A
Upper side
• Be sure to use 2 people when installing the Wide LCD Monitor to the base bracket.
• Be sure to perform Steps Å and ı below. Just performing Step Å could result in the display falling off, which is very
dangerous.
Install the wall-mount bracket attached to the Wide LCD Monitor to the base bracket.
Å Hang the square holes ( ) of the wall-mount bracket on the hooks (page 24) of the base bracket.
ı Tighten the wall-mount bracket and base bracket screws. (Be sure to do this.)
Caution
Tighten from the bottom.
M5 screws 8mm length (2 screws)
Wall
Base bracket
Make sure the hooks are
engaged.
Wide LCD
Monitor
Å ı
M6 30mm length
Upper side
Attaching wall-mount bracket to LC-M3710 (vertical
mount)