Sony NSR-1100 User Manual

Page 17

Advertising
background image

NSR-1000 Series v1.1.1 Release Note

The image size of more than QVGA(320x240) is selected, the maximum

frame rate is limited at the transmission side as follows:

NTSC: 10 fps or less
PAL: 8 fps or less

If the cameras mentioned below uses the MPEG4 codec with the image size of

more than 384x288, the maximum frame rate is limited at transmission side.
(V11N:59)

SNC-CS50, SNC-DF50/DF80/DF85, SNC-RX530/RX550/RX570, SNC-RZ50

15(NTSC)/20(PAL) fps or less with the stabilizer set to on

20(NTSC)/16(PAL) fps or less when the dual codec including JPEG and
anything is selected, or while the motion detection is working

When you want to select the image size of more than 4CIF on the SNC-DF85,

the firmware version of the camera should be V1.20 or higher. If the former
version, do not select 4CIF in the image size setting. (V11N:226)

To configure the camera protocol on camera servers SNT-EX series connected to

analog cameras, access the setting page through the web browser of the
SNT-EX series. (V11N:169)

With regard to the SNT-EX154, audio data of channel 1 only is output through
CH1 AUDIO OUT connector of the SNT-EX154.(V11N:283)

I/O pins of the SNT-EX series are shared with all the video channels. It is
possible for the channel 1 to use all the I/O pins, or for each channel to use each
pin one by one.
If the output pins are shared with two or more video channels, there may be
some inconsistencies occurring. To work around this, it is recommended to
assign output pins to any one of the channels. (V11N:284)

The detection area configuration in the VMD (Camera) Configuration screen is
performed based on the VGA (640x480) coordinate system. Note that it shows

- 13 -

Advertising
This manual is related to the following products: