Sony NSR-1100 - Manual (Page 42)

NSR-1000 Series v1.1.1 Release Note
５-２-２ Resolved limitations in V1.0.4
５-２-２-１ Installation / System Configuration
・ When saving the system configuration information in Control Menu, the
prohibited characters such as ＃,＄,％ can be used in the file name. However,
you should not use those characters, because it is not possible to save it when
using them. (VT1:1413)
５-２-２-２ Server Configuration
・ The problem that the confirming dialog is shown when monitoring window is
displayed or it logoff, if “Apply” button is not pushed, “Close” button is pushed
and the setting changes are not saved in [E-mail] tab at Server setting window.
(VT1:2022)
・ The network information on the server setting screen cannot be displayed when
used in German. (VT1:2242)
５-２-２-３ Main Window: Monitoring
・ When double clicking a monitor frame during playing back with audio in Main
GUI (1x1 mode), there might be an occasion that audio playback stops.
(VT1:1096)
・ When using the IP Desktop USB controller from CH Products, GUI may freeze
or terminates abnormally by pushing the Preset button on the IP Desktop USB
controller with the camera which does not support preset function.
(VT1:2054)
・ The image might flicker when the resolution is relatively high in the JPEG
image. In this case, it flickers even if the images are recorded and played.
(VT1:2182)
・ In the case of alarm recording of VMD(Camera) at SNT-V704, red frame should
be displayed, but it will be done on the screen at all channels of SNT-V704.
(VT1:2187)
- 38 -