Sony NSR-1100 - Manual (Page 27)

NSR-1000 Series v1.1.1 Release Note
selected, actual frame rate is 1fps. (VT1:1842)
・ You can change multiple registration details by selecting two or more cameras
at time, if they are all the same model. If 29 or more cameras are selected,
however, there are cases where the maximum value cannot be selected from the
list. To work around this, select up to 28 cameras. (V11N:43)
・ When changing any value on [Video] tab on Device Configuration Screen, be
sure to press “Apply” button before moving to the other tab. If you do so without
pressing “Apply” button, when you return to [Video] tab, you can see the value
just before changing. If you press “Apply” button from the above situation,
however, the changed value (different from the displayed one) is applied.
(V11N:61)
・ When configuring masks with [Freeze image during PTZ movement] selected
for the cameras with the PTZ functions, rendering is stopped during PTZ
movement if there is any mask(s) in the area, and it continues if not. In the case
that the PTZ movement is performed across the areas without and with masks,
rendering starts and then stops at the timing when the camera enters the area
including the mask.
If the PTZ movement is too fast to stop rendering in such case, rendering may
continue even in the area including the mask. To work around this, let the
camera slowly move to the area including the mask. When configuring masks,
be sure to adjust the width and height of the mask while checking the PTZ
movement. When configuring the camera tour, be sure to check the mask size
and the speed of the tour. (V11N:150)
・ When opening the configuration screen just after registering the following
cameras/camera servers, some tabs like [Physical Sensor In] may not be
displayed. Or the parameters for PAL model may be listed under Image Size or
Frame Rate on [Video] tab regardless of use of NTSC camera. To work around
this, confirm that the image is monitored by clicking [General] tab, select
another camera once in the camera tree and then reselect the target camera.
- 23 -