Sony NSR-1100 - Manual (Page 28)

NSR-1000 Series v1.1.1 Release Note
(V11N:363,V11N:446)
In addition, when making the Device configuration settings continuously,
there are infrequent cases where a part of set values etc., is not displayed by
screen refresh even after the settings are applied. In this case, select another
camera once in the camera tree and then reselect the target camera.
(V11R:521)
SNC-RH series
SNC-RS series
SNT-EP series
SNT-EX series
・ Using the following cameras/camera servers, the preview feature of the motion
detection is not activated in the Configuration window while configuring the
VMD(Camera). To pre-check the motion detection, apply the settings, return
the main screen and assign the target camera to any of monitor frames.
(V11N:304)
SNC-RH series
SNC-RS series
SNT-EP series
SNT-EX series
・ When changing a camera name on [General] tab after camera registration, the
set values may be displayed blank. In this case, close the Device configuration
screen once, and then re-open it. (V11N:383)
・ When specifying a preset name for the following cameras/camera servers, a
space cannot be used in the preset name.(V11N:399)
SNC-RH series
SNC-RS series
SNT-EP series
SNT-EX series
・ After changing resolution settings for a camera which has some masks, please
- 24 -