Sony NSR-1100 - Manual (Page 30)

NSR-1000 Series v1.1.1 Release Note
・ If user modifies recording settings in ‘Schedule Configuration’ such as alarm to
event, the NSR-1000 Series doesn’t reload the default recording settings (codec
/ Image Size / Image Quality / Bit Rate / Frame Rate) on ‘Video’ tab in the
‘Device Configuration’ automatically. Please click ‘Adjust to Camera
Configuration’ at the bottom of ‘Schedule Configuration’ Window and reload the
last settings manually. (VT1:1925)
・ The NSR-1000 Series has the following limitation of the number of cameras to
be set as alarm recording because of avoiding overload in ‘Automatic Alarm
Recording’. (VT1:1749)
NSR-1200 - up to 24 cameras
NSR-1100 - 12 cameras
NSR-1050H – 12 cameras
・ In the Schedule Configuration, after closing the “New Action” dialog, when
"Close" button is clicked without pressing "Apply" button, a confirmation
message will not be displayed. Preservation is done without the preservation
confirmation message appearing, and set it to former setting again, please
when you want to cancel at that time. (VT1:2243)
・ When configuring the schedule for the event/alarm recording, you can specify
all triggers configured for NSR (regardless of whether the camera is used for
the record or not) by selecting “Show All Triggers” select box.
When displaying the configuration again after the settings are saved, however,
you can see that this check box become unchecked. To confirm the trigger status,
again check this “Show All Triggers” check box. (V11N:241)
・ The problem that the system is used in an area where daylight saving time
(DST) is in effect. After DST starts/ends, actions triggered by the schedule do
not work properly. To prevent this, be sure to restart the system and
reconfigure the action schedule after switching over DST. (V11R:560,V11R:561)
- 26 -