Sony NSR-1100 - Manual (Page 21)

NSR-1000 Series v1.1.1 Release Note
・ When you change the video-related options (Image Size, Image Quality and
Frame Rate) on the [Video] tab while monitoring/recording a JPEG image an
AXIS camera is capturing, monitoring or recording may continue with the
previous settings. To enable the changed values in monitoring, be sure to logoff
once, and then logon. To enable the changed values in recording, be sure to
deselect the [Enable] check box to enable the schedule on the Record dialog box,
and then select it to apply. (VT3:914)
・ When you configure the e-flip for an AXIS camera of which codec is set to JPEG,
monitoring or recording may continue without the video flipped vertically. To
enable the e-flip in monitoring, be sure to logoff once, and then logon. To enable
the e-flip in recording, be sure to deselect the [Enable] check box and apply,
select the [Enable] check box again to enable the schedule on the Record dialog
box, and then select it to apply. (VT3:912)
・ AXIS camera’s preset name can’t be changed to other name after it was set.
Please delete it and set it again. (VT1;2159)
・ The DIRECT PTZ function is not supported on AXIS video servers or PTZ
cameras. To achieve this function, use the buttons in the Camera Control pane
or the remote controller. (V11N:400)
・ AXIS camera acquires images by RTSP using port 554 when MPEG4 codec is
selected. Therefore, when using AXIS camera with the codec set to MPEG4, do
not disable RTSP on the camera. And keep the port number default
(automatically). (V11N:409)
In addition, when using AXIS camera with the codec set to MPEG4,
connection via Proxy is impossible, because the NSR-1000 series supports only
the HTTP Proxy server in connection with the camera.
When you want to connect to the camera via Proxy, set the codec to JPEG.
(V11N:411)
・ With IQinVision camera with 2M pixels, the frame rate may halve compared to
- 17 -