Sharp DT-400 - Manual (Page 28)

-28
STANDBY
button
STANDBY
button
Info
• Do not unplug the power cord during projec-
tion or cooling fan operation. The cooling fan
in this projector continues to run for about 90
seconds after the projector enters the standby
mode. This can cause damage due to rise in
internal temperature, as the cooling fan also
stops.
Turning the Power Off
(Put-
ting the Projector into Standby Mode)
1
Press on the projector or
on the remote control, then press
that button again while the confir-
mation message is displayed, to
put the projector into standby
mode.
▼On-screen Display
2
Unplug the power cord from the AC
outlet after the cooling fan stops.
Turning the Projector On/Off
DT400_E_P27_35.p65 04.10.18, 1:18 PM 28