Sharp DT-400 - Manual (Page 48)

-48
Setting the Video System
The video input system mode is factory preset
to “Auto”; however, a clear picture from the con-
nected audio-visual equipment may not be re-
ceived, depending on the video signal difference.
In that case, switch the video signal.
Menu operation Page 40
Example: “Options” menu screen for
INPUT 4 mode
Description of Video Systems
Note
• The video signal can only be set in INPUT 3,
INPUT 4 mode.
• “Auto” cannot be set for PAL-M and PAL-N in-
put signals. Select “PAL-M” or “PAL-N” in “Video
System” menu for PAL-M and PAL-N input sig-
nals.
Description
When connected to PAL video equip-
ment.
When connected to NTSC video
equipment.
When connected to SECAM video
equipment.
When reproducing NTSC signals in PAL
video equipment.
Selectable items
PAL
NTSC3.58
SECAM
NTSC4.43
Signal Type Setting
This function allows you to select the input sig-
nal type RGB or Component for INPUT 5.
Menu operation Page 40
Example: “Options” menu screen for
INPUT 5 (RGB) mode
Description of Signal Type Settings
Description
Set when RGB signals are received.
Set when Component signals are
received.
Selectable items
RGB
Component
Note
• You can also select “Signal Type” using
on the remote control (only INPUT 5).
Using the “Options” Menu
DT400_E_P47_52.p65 04.10.18, 1:24 PM 48