Samsung Version 1.1 - Manual (Page 23)

23
Chapter 4 Setting an IP Address
Ethernet address (00-00-f0-XX-XX-XX) is recorded on the bottom of the
product at the time of purchase. Because it may be accidentally erased,
please duplicate the number and keep it somewhere else.
Caution
No information upon network is set up except Ethernet address (MAC address) in factory defaults. You
must set up the IP address when installing.
Before You Begin
(1) Confirm the Ethernet address (00-00-f0-XX-XX-XX) on the bottom of SNS-110. You must keep this
number for IP address set-up.
(2) Confirm the normal power supply of SNS-110.
(3) Confirm the proper connection with network.
When properly connected to network with Ethernet environment, the front network LED blinks.
(4) To use your SNS-110 under the Ethernet(10BaseT/100BaseT) environment, an unused IP address
must be assigned to SNS-110 from a network manager.
At this time, check the following network related information.
● IP Address
● Gateway
● Subnet Mask
● Domain Name
● DNS
(5) If you set up an IP address through DHCP server in network environment, and if SNS-110 is
properly connected to network, you will automatically be assigned with an IP address, gateway, and
subnet mask by turning the power on. Confirm this auto-assigned IP address from RS-232C
connected PC terminal emulation (HyperTerminal).
Please, refer to "Connecting to RS-232C" and APPENDIX C "How to Use Console".
Refer to the Appendix D, "Dynamic IP information Transfer" to send Dynamically Assigned IP
Address to the administration server.
(6) Set up an IP address, according to network environment as following.
You must appropriately set up an IP address abiding by your network environment.