Samsung Version 1.1 - Manual (Page 29)

29
If the serial port which you select is being used by other device, you will see the following
window.
In this case, you have to stop the usage of serial port by other device or change the
connection of SNS-110 to other serial port.
Note
(4) If the SNS-110 and PC is successfully connected through RS-232C cable, you will see the following
window.
(5) In obedience to the 'Comments' of the program, reset SNS-110 by pushing the 'RESET' button or by
turning off and on of SNS-110. Then, the present state of network parameters of SNS-110 will be
displayed.
If nothing is displayed in the program, check the serial connection of SNS-110 and PC, and then repeat
the above procedure.
For more detail information of the network parameters, please refer to the 'Network Set-up' of
Chapter 7.
Note