Samsung Version 1.1 - Manual (Page 32)

32
Please, refer to Chapter 5 and 7 for Log-in and administration mode network
setting up.
Note
Setting Other Network Information
After successfully setting up the IP address in Ethernet, follow the next procedure to set up additional
network information.
After the previous procedure, you must set up the following information, confirmed by the network
manager, to connect to network successfully.
● Gateway
● Subnet Mask
● Domain Name
● DNS
(1) Open a web browser (Netscape or Explorer) from the network-connected PC or Unix machine with
SNS-110 installed.
(2) Log-in with the SNS-110 IP address set up through the web browser. You must enter the exact ID and
password.
The initial user name and password are shown below.
● User Name : root
● Password : w2000
(3) After logged in, set up the additional network information in administration mode.
(4) Be sure to reset or switch off and then switch on your SNS-110 after setting.
Changing IP Address
(1) To change the present IP address, log in with the present IP address. Then, change the IP address
in network set-up of administration mode.
Refer to Chapter 7. setting Administration Mode Network.
(2) Refer to APPENDIX B "Factory Default", to set up the factory default and set up a new IP address
according to Chapter 4, Setting an IP Address.