Sanyo PLC-WU3800 - Manual (Page 15)

15
Installation
Installation
Connecting to a Computer
Cables used for connection
• VGA cables (Mini D-sub 15 pin) *
• Audio cables
• HDMI-DVI cable
(*One cable is supplied; other cables are not supplied with the projector.)
P
Note:
• Input sound to the COMPUTER1 COMPONENT/COMPUTER
2 AUDIO IN terminal when using the COMPUTER IN 1/
COMPONENT IN and the COMPUTER IN 2/MONITOR OUT
terminal as input.
• When the AUDIO OUT is plugged-in, the projector's built-in
speaker is not available.
• When the cable is of the longer variety, it is advisable to
use the COMPUTER IN 1 / COMPONENT IN and not the
COMPUTER IN 2.
Unplug the power cords of both the
projector and external equipment
from the AC outlet before connecting
cables.
External Audio Equipment
Audio cable
(stereo)
Audio cable
(stereo)
Audio Output
COMPUTER 1 COMPONENT/
COMPUTER 2 AUDIO IN
AUDIO OUT
(stereo)
Audio Input
Monitor
Output
COMPUTER IN 2 /
MONITOR OUT
VGA
cable
COMPUTER IN 1
COMPONENT
VGA
cable
Monitor Output /
Monitor Input
HDMI-DVI
cable
DVI
Output
HDMI
This terminal is
switchable. Set up
the terminal as
COMPUTER IN 2 or
MONITOR OUT.(See
Page 51.)
P
Note:
• Analog RGB and component signals cannot be
output from the COMPUTER IN 2/MONITOR
OUT terminal when using the COMPUTER IN
2/MONITOR OUT terminal as output.
• When DVI signal is connected to HDMI terminal
with HDMI-DVI cable, connect the sound signal
to COMPUTER 2 AUDIO IN and set up Sound of
"HDMI setup" to "Computer2". (p.51)