Sanyo PLC-WU3800 - Manual (Page 65)

65
Maintenance and Cleaning
When the projection lamp of the projector reaches its end
of life, the Lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights yellow. Replace the
lamp with a new one promptly. The timing when the LAMP
REPLACE indicator should light is depending on the lamp
mode.
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Allow a projector to cool for at least 45 minutes
before you open the Lamp Cover. The inside of
the projector can become very hot.
CAUTION
Lamp Replacement
CAUTION
Top Control
LAMP REPLACE
indicator
Lamp replacement icon
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
● Model No . of your projector : PLC-WU3800
● Replacement Lamp Type No . : POA-LMP111
(Service Parts No . 610 333 9740)
Follow these steps to replace the lamp.
Turn off the projector and unplug the AC power cord.
Let the projector cool for at least 45 minutes.
Loosen the two (2) screws that secure the lamp. Lift
the lamp out of the projector by using the handle.
1
3
Replace the lamp with a new one and secure the two
(2) screws. Make sure that the lamp is set properly.
Close the lamp cover and secure the screw.
4
Remove the screw and open the lamp cover.

Connect the AC power cord to the projector and turn
on the projector.
6
Reset the lamp counter .
See “Resetting the Lamp Counter” on the next page.
5
Handle
Screw
Lamp Cover
Press here and pull upward.
Screw
Lamp
Screw
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
P
Note:
The Lamp replacement icon will not appear when the Display function
is set to Off (p.47), during "Freeze" (p.26), or "No show" (p.27).