Sanyo PLC-WU3800 - Manual (Page 50)

50
Setting
Enter a Logo PIN code
Use the Point ▲▼ buttons to enter a number. Press the
Point ► button to fix the number and move the red frame
pointer to the next box. The number changes to ⁄ . If
you fixed an incorrect number, use the Point ◄ button to
move the pointer to the number you want to correct, and
then enter the correct number.
Repeat this step to complete entering a four-digit
number.
After entering the four-digit number, move the pointer to
Set. Press the SELECT button so that you can start to
operate the projector.
If you entered an incorrect Logo PIN code, Logo PIN
code and the number ( ⁄ ⁄ ⁄ ⁄ ) will turn red for a
moment. Enter the correct Logo PIN code all over again.
Logo PIN code can be changed to your desired four-
digit number. Press the Point ▼ button to select Logo
PIN code change and then press the SELECT button.
Logo PIN code dialog box appears, use the point ▲▼
buttons to enter the current code. The New Logo PIN code
input dialog box appears. Set a new Logo PIN code.
Be sure to note the new Logo PIN code and keep it
on hand. If you lost the number, you could no longer
change the Logo PIN code setting. For details on
PIN code setting, refer to "PIN code lock" on pages 57-
58.
Use the Point ▲▼ buttons to switch On or Off, and then
press the SELECT button to close the dialog box.
Change the Logo PIN code lock setting
Enter a Logo PIN code
After a correct Logo PIN code
is entered, the following dialog
box appears.
CAUTION:
WHEN yOU HAVE CHANGED THE LOGO PIN
CODE, WRITE DOWN THE NEW PIN CODE
IN COLUMN OF THE LOGO PIN CODE NO .
MEMO ON PAGE 81, AND KEEP IT SECURELy .
SHOULD THE LOGO PIN CODE BE LOST OR
FORGOTTEN, THE LOGO PIN CODE SETTING
CAN NO LONGER BE CHANGED .
Change the Logo PIN code lock setting
Logo PIN code change
Change the Logo PIN code