Skil 3700 - Manual (Page 46)

ON/OFF INCH/MM ZERO
FIG. 12
T5
T9
T24
46.
Attaching Digital Display
Locate the digital display assembly T5 , 3 AA batteries T14, and 2
end caps for the front rail from among the loose parts.
1. Install 3 size AA batteries in the digital display assembly T5 as
shown. (Fig. 11)
2. Slide the digital display assembly onto the rail T9 from the right-
hand side so that the assembly has captured the profile of the
rail. (Fig. 12)
3. Install the rail end caps T24 onto the right and left ends of the
rail.
4. Follow instructions on setting and using the digital display in the
operation section of this manual.
Attaching Handle To Rip Fence
Locate the rip fence assembly T3 and the rip fence handle T18
(Fig. 13) from among the loose parts.
1. Thread handle into the rip fence.
2. Tighten hex jam nut to lock handle against cam (Fig. 13).
IMPORTANT: Apply a coat of paste wax to the top surface and
front edge of the front guide rail. This will allow the fence to slide
more easily.
A
A
A
A
A
A
FIG. 11
T14
T5
T3
FIG. 13
T18
FIG. 11
FIG. 12
FIG. 13