SMC Networks ProSoft 1560 - Manual (Page 4)

4
Contents
Quick Start Guide
In this section we have assembled a simple step-by-step procedure for
installing and making the 1560-MBP unit operational. This discussion
presumes that the application decisions such as Modbus Plus
addressing and hierarchy, SCANport cable length, etc. have been
addressed prior to this point.
Step-by-Step
The following steps will allow the 1560-MBP to be setup in the shortest
period of time (the following steps refer to the Allen-Bradley drive
implementation. Similar steps are followed when interfacing to other A-B
Power Division products):
1 Set the dip switches
The 1560-MBP dip switch positions are detailed in Section 3
2 Mount the 1560-MBP on the DIN rail
See Appendix D for mounting instructions.
3 Connect power to the 1560-MBP
Refer to Section 3
4 Setup the Drive hardware
Refer to the appropriate drive manual to connect control and
power to the drive. This aspect of the drive installation is out
of the scope of this manual.
5 Setup the Drive parameters
See Appendix B of the manual to setup the drive parameters
6 Install the SCANport cable between the drive and the
1560-MBP.
7 Connect the Modbus Plus communication cable between
the host system and the 1560-MBP. The procedure follows
standard Modbus Plus cabling practices.
Quick Start Guide