SMC Networks ProSoft 1560 User Manual
Page 44
44
Power, input and output (I/O) wiring must be in accordance with
Class I, Division 2 wiring methods, Article 501-4 (b) of the
National Electrical Code, NFPA 70 and Section 18-152 for
installation within Canada.
A. This equipment is suitable for use in Class I, Division 2,
Groups A, B, C, and D or nonhazardous locations only.
B. Warning – Explosion hazard – Substitution of components
may impair suitability for Class I, Division 2.
C. Warning – Explosion hazard – When in hazardous locations,
turn off power before replacing or wiring modules.
D. Warning – Explosion hazard – Do not disconnect equipment
unless power has been switched off or the area is known to
be nonhazardous.
9801 Camino Media
Suite 105
Bakersfield, CA 93311
(661) 664-7208
(661) 664-7233 Fax
e-mail : [email protected]