Sony STR-DH810 - Manual (Page 40)

40 GB
* xxx represent a speaker channel
FL Front left
FR Front right
CNT Center
SL Surround left
SR Surround right
SBL Surround back left
SBR Surround back right
LH Front left high
RH Front right high
SW Subwoofer
Depending on the measurement result, the speaker
channel may not appears.
To return to step 2 of
“3: Confirming/saving the
measurement results”
Press .
Tip
Depending on the position of the subwoofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
You can use the AUTO CAL menu to make
various adjustments for Auto Calibration
settings and to name the position.
For details on adjusting the parameters, see
“Using the setting menu” (page 72).
x A.CAL START
x CAL TYPE*
Lets you select the Auto Calibration type for
each seating position. For details, see step 4 of
“3: Confirming/saving the measurement
results” (page 38).
* You can select this parameter only when you have
performed the Auto Calibration and saved the
settings.
x POSITION
You can register three patterns as position 1, 2
and 3, depending on the seating positions,
listening environment, and measurement
conditions.
If you do not select the position number, the
Auto Calibration result will automatically save
as POS 1 (initial setting).
To register settings for the
listening environment
You can select the seating position you want
and register the measurement results of the
Auto Calibration for that seating position.
1 Press AMP MENU.
2 Press V/v repeatedly to select “<AUTO
CAL>”, then press or b.
3
Press V/v repeatedly to select
“POSITION”, then press or b.
4 Press V/v repeatedly to select the
position (POS 1, 2, 3) for which you
want to register the measurement
results, then press
.
W - xxx * : 42
The volume of the receiver is out of the acceptable
range. Try to perform the measurement when the
environment is quiet enough to allow proper
measurement.
W - xxx * : 43
The distance and position of a subwoofer cannot be
detected. This may be caused by noise. Try to
perform the measurement in a quiet environment.
NO WARN
There is no warning information.
Display and explanation AUTO CAL menu