Sony STR-DH810 - Manual (Page 49)

49 GB
T
u
n
e
r Op
era
tio
ns
4
Press MEMORY.
You can also use MEMORY/ENTER on
the receiver.
“MEM” lights up for a few seconds.
Perform steps 5 and 6 before “MEM”
goes out.
5
Press the numeric buttons to
select a preset number.
You can also press PRESET + or
PRESET – repeatedly to select a preset
number.
If “MEM” goes out before you select the
preset number, start again from step 3.
6
Press ENTER.
You can also use MEMORY/ENTER on
the receiver.
“MEM” lights off.
The station is stored as the selected preset
number.
7
Repeat steps 1 to 6 to preset
another station.
1
Press TUNER repeatedly to
select the FM or AM band.
2
Press PRESET + or PRESET –
repeatedly to select the preset
station you want.
Each time you press the button, you can
select a preset station as follows:
You can also press SHIFT and then press
the numeric buttons to select the preset
station you want. Then, press ENTER to
enter the selection.
Using the controls on the
receiver
1 Turn INPUT SELECTOR to select the FM
or AM band.
2 Press TUNING MODE repeatedly to select
“PRESET”.
3 Press TUNING + or TUNING – to select the
preset station you want.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Tune in the preset station you
want to create an index name
for (page 49).
3
Press AMP MENU.
4
Press V/v repeatedly to select
“<TUNER>”, then press or
b.
Tuning to preset stations
Naming preset stations
1 2 3 4 5 27 ...
30 29 28
continued