Samsung SRP-500 - Manual (Page 13)

17
2-5. You want to check a software program.
• Hexadecimal Dump
This feature allows experienced users to see exactly what data is coming
to the printer. This can be useful in finding software problems. When you
turn on the hexadecimal dump function, the printer prints all commands
and other data in hexadecimal format along with a guide section to help
you find specific commands.
To use the hexadecimal dump feature, follow these steps:
1) After you make sure that the printer is off, open the front cover of the
printer.
2) Hold down the Feed button while you turn on the printer.
3) Close the front cover.
4) Run any software program that sends data to the printer. The printer
prints “Hexadecimal Dump” and then all the codes it receives in a two –
column format. The first column contains the hexadecimal codes and
the second column gives the ASCII characters that correspond to the
codes.
• A period(.) is printed for each code that has no ASCII equivalent.
5) When the printing finishes, turn off the printer.
18
Chapter 3
DIP switch settings
Although the factory settings are best for almost all users, if you have special
requirements, you can change the DIP switch.
3-1. Setting the DIP switches
• DIP switch functions
Your printer has two sets of DIP switches.
The functions of the switches are shown in the following table.
DIP - SW1
Switch Function ON OFF Default
1-1 OFF
1-2
Emulation Selection Refer to the following table
OFF
1-3 Auto cutter Enable Disable OFF
1-4 Cartridge one cartridge two cartridges OFF
1-5 Density *1) Bold Normal OFF
1-6 Special Function *2) Enable Disable OFF
1-7 Near end sensor Enable Disable OFF
1-8 Low ink check Disable Enable OFF
1-1 1-2
EPSON OFF OFF
STAR OFF ON
CITIZEN ON OFF
EPSON-KP *3) ON ON
DIP - SW2 (RS232C Serial interface model)
Switch Function ON OFF Default
2-1 Data receive error Print “?” Ignore OFF
2-2 Reserved OFF
2-3 Hand
Shaking DTR/DSR XON/XOFF OFF
2-4 Word length 7bit 8bit OFF
2-5 Parity check Enable Disable OFF
2-6 Parity selection EVEN ODD OFF
2-7 OFF
2-8
Baud rate selection Refer to the following table
OFF
DIP - SW2 (Parallel interface model)
Switch Function ON OFF Default
2-1 Auto Line Feed Enable Disable OFF
2-2 OFF
2-3 OFF
2-4 OFF
2-5 OFF
2-6 OFF
2-7 OFF
2-8
Undefined
OFF