Samsung SRP-500 User Manual
Page 31
53
ESC c 3 n
[Name]
Select paper detector(s)to output paper end signals
[Format]
ASCII
ESC
c
3
n
Hex
1B
63
33
n
Decimal 27
99
51
n
[Range]
0 ≤ n ≤ 255
[Description]
Selects paper detector(s) to output paper end signals,
using n as follows:
Bit
Off/On
Hex
Decimal
Function
Off
00
0
Paper roll near end sensor disabled.
0
On
01
1
Paper roll near end sensor enabled.
1
Off
00
0
Paper roll near end sensor disabled.
On
02
2
Paper roll near end sensor enabled.
Off
00
0
Paper roll end detector disabled.
2
On
04
4
Paper roll end detector enabled.
Off
00
0
Paper roll end detector disabled.
3
On
08
8
Paper roll end detector enable.
4 - - -
Undefined
5 - - -
Undefined
6 - - -
Undefined
7 - - -
Undefined
[Notes]
• It is possible to select multiple detectors to output signals.
• Then, if any of the detectors detects a paper end, the paper end signal is
output.
• Detectors are switched when executing this command.
• Because of this, the paper-out signal switching may delay depending on
the receive buffer state.
[Default]
n = 15
54
ESC c 4 n
[Name]
Select paper sensor(s)to stop printing
[Format]
ASCll
ESC
c
4
n
Hex
18
63
34
n
Decimal 27
99
52
n
[Range]
0 ≤ n ≤ 255
[Description]
Selects the paper sensor(s) used to stop printing when a
paper-end is detected, using n as follows :
Bit
Off/On
Hex
Decimal
Function
Off
00
0
Paper roll near end sensor disabled.
0
On
01
1
Paper roll near end sensor enabled.
Off
00
0
Paper roll near end sensor disabled.
1
On
02
2
Paper roll near end sensor enabled.
2 - - -
Undefined
3 - - -
Undefined
4 - - -
Undefined
5 - - -
Undefined
6 - - -
Undefined
7 - - -
Undefined
[Notes]
• The printer goes off-line after printing stops.
• The paper roll near-end sensor is an option, therefore, if the paper roll
near-end sensor is enabled by this command when the sensor is not
equipped, it does not stop printing.
• The paper roll near-end sensor is enabled when either bit 0 or 1 is 1.
• The paper roll end sensor is a sensor which is always used to make an
effective to stop printing.
[Default]
n = 0