Samsung SRP-500 - Manual (Page 7)

5
1-3. Connecting the cables
• Plugging in AC adapter
CAUTION
• Before connecting the printer to the power supply, make sure that the
voltage and power specifications match the printer’s requirements.
• Using an incorrect power supply can cause serious damage to the
printer.
Connect the AC adapter according to the following procedure.
1) Make sure the printer is turned off.
2) Plug the AC adapter cable into the printer’s power connector.
3) Plug the power cord into the outlet, and turn on the power.
6
• Connecting the interface cable
Connect the printer to the host ECR (host computer) though an interface
cable matching the specification of the printer and the host ECR (host
computer).
Be sure to use a drawer that matches the printer’s specification.
Depending on the interface your system uses, either connect the serial,
parallel or USB communication cable to the appropriate connector on the
back of the printer.
Cables are provided by your dealer or system installer.
Connect the interface cable according to the following procedure.
1) Turn off printer and the ECR (host computer) host.
2) Plug the interface cable into the interface connector on the printer then
fasten the screw on both sides of the connector.
3) Plug the drawer kick-out cable into the drawer kick-out connector on
the printer. (When removing the drawer kick-out cable, press on the
connector’s clip while pulling out.)