Samsung SRP-500 - Manual (Page 39)

69
GS r n
[Name] Transmit status
[Format] ASCII GS r n
Hex 1D 72 n
Decimal 29 114 n
[Range] 1 ≤ n ≤ 2, 49 ≤ n ≤ 50
[Description] Transmits the status specified by n as, follows:
n Function
0, 48 Transmits paper sensor status
1,49 Transmits drawer kick-out connector status
[Notes]
• This command is executed when the data in the receive buffer is
developed. Therefore, there may be a time lag between receiving this
command and transmitting the status, depending on the receive buffer
status.
• The status types to be transmitted are shown below:
Paper sensor status (n = 1, 49)
Bit Off/On Hex Decimal Status for ASB
Off 00 0 Paper near-end sensor: paper present. Paper
nearend 0, 1
On 03 3 sensor: paper near end.
Off 00 0 Paper end sensor. Paper present. Paper end
sensor:
On 0C 12 no paper present.
2, 3
4
Off 00 0 Not used. Fixed to Off.
5 Off 00 0 Not used. Fixed to Off.
6 Off 00 0 Not used. Fixed to Off.
7 Off 00 0 Not used. Fixed to Off.
Drawer kick-out connector status (n = 2,50)
Bit Off/On Hex Decimal Status for ASB
Off 00 0 Drawer kick-out connector pin 3 is LOW. Drawer 0
On 01 1 kick-out connector pin 3 is HIGH.
1 Off 00 0 Not used. Fixed to Off.
2 Off 00 0 Not used. Fixed to Off.
3 Off 00 0 Not used. Fixed to Off.
4 Off 00 0 Not used. Fixed to Off.
6 Off 00 0 Not used. Fixed to Off.
7 Off 00 0 Not used. Fixed to Off.
70
Chapter 6
Reference information
6-1. Printing specification
Printing method Serial ink jet matrix method
Printing direction Bidirectional(logic seeking) with friction feed
Resolution
104 x 96(dpi): Text
208 x 96(dpi): Graphic
Characters per line Max 42(characters)
Printing speed
6.5 LPS (Lines Per Second)
at 40 columns
Printing Width 61.5mm
Line Interval 4.233mm (1/6”)
Character sets
Alphanumeric characters: 95
International characters: 32
Extended graphics: 128 x 12 pages
Character font 12 x 12 / 12 x 14
6-2. Paper specification
• Paper roll
Type
Normal paper
Size Width : 76 ± 0.5(mm)
Thickness 0.06 to 0.09(mm)
Maximum outside diameter ø 83mm
Paper core inside diameter ø 10 to 12.5(mm)
6-3. Ink cartridge specification
Model HP 6602X
Firing frequency
3.0KHz – low density printing(Text)
1.5KHz – high density printing(Graphic)
Operating Voltage 19.9 ± 0.5V
Resistance 60 Ω
Operating Temperature 10~40 °C
Date of expiration
Two years after production
(at normal temperature)
Notice
Follow the laws or regulations of your country or community for disposing of
used ink cartridges.