Samsung SV-DVD54T - Manual (Page 19)

ENG-18
Recording a Programme
Immediately
Before recording a programme, you must have preset
the corresponding station (unless you are recording via
an external video source). If you have not done so,
refer to pages 11.
1 Switch on the television.
2 To monitor the programme being recorded, select
the television channel reserved for use with your
STB-DVD-VCR (or the LINE input if used).
3 Insert the cassette on which the programme is to be
recorded, with the window visible and the safety tab
intact or the opening covered with adhesive tape.
4 Select:
◆ The station to be recorded using the PROG
( or ) buttons and SELECT (VCR or STB)
buttons or
◆ The LINE1, LINE2 source using the INPUT
SEL. button for external video source
Result: The station number is displayed and the
programme can be seen on the
television.
5 Select the recording speed by pressing the SPEED
button as many times as required (see page 17).
6 Hold the REC button ( ● ) down for a while to start
recording.
Result: The record indicator appears on the
television and STB-DVD-VCR display. An
index is recorded on the tape (see page
24).
7 To stop recording, press ■ once.
➢
◆ If your STB-DVD-VCR ejects the cassette
when you start recording, check to make sure
that the cassette’s safety tab is intact or that
the opening (created by a broken safety tab) is
covered with adhesive tape.
◆ If you reach the end of the tape while
recording, the cassette rewinds automatically.
◆ If STB view changes to VCR view during
recording, the change of channel is impossible.
◆ VCR function key is not operated for Play, FF,
REW on STB view.
Recording a Programme with
Automatic Stop
This function enables you to record up to nine hours
(LP) of programmes.
Your STB-DVD-VCR stops automatically after the
requested length of time.
1 Switch on the television.
2 To monitor the programme being recorded, select
the television channel reserved for use with your
STB-DVD-VCR (or the LINE input if used).
3 Insert the cassette on which the programme is to
be recorded, with the window visible and the safety
tab intact or the opening covered with adhesive tape.
4 Select:
◆ The station to be recorded using the PROG
( or ) buttons and SELECT (VCR or STB)
buttons or
◆ The LINE1, LINE2 source using the INPUT
SEL. button for external video source
Result: The channel number is displayed and the
programme can be seen on the television.
5 Select the recording speed by pressing the SPEED
button as many times as required (see page 17).
6 Hold the REC button ( ● ) down for a while to start
recording.
Result: The record indicator appears on the
television screen and STB-DVD-VCR
display. An index is recorded on the tape
7 Press the REC button ( ● ) several times to increase
the recording time in:
◆ 30-minute intervals up to four hours
◆ 1-hour intervals up to nine hours
Result: The length is displayed on the television
displays. The selected programme is
recorded for the length of time requested.
At the end of that time, the STB-DVD-VCR
stops recording automatically and power off.
8 If you wish to cancel the recording before the end,
press STANDBY/ON.
☛
If the end of the tape is reached while recording:
◆ The recording stops and power off.
☛
This function is not available in DVD recording
LENGTH 2:30
SET LENGTH :
PRESS REC ●