Samsung SV-DVD54T - Manual (Page 20)

ENG-19
Using the G-CODE Feature
◆ The programme number or times flash
◆ You wish to modify the programme
4 If the programme and times are correct, press the
RETURN button.
5 Press the STANDBY/ON button to activate the
timer.
6 Refer to page 21~22 if you wish to:
◆ Check that your STB-DVD-VCR has been
programmed correctly
◆ Cancel a preset recording
☛
The numbers next to each TV programme listing
are G-Code code numbers, which allow you to
programme your STB-DVD-VCR instantly with
the remote control. Tap in the G-Code code for
the programme you wish to record.
™G-Code is a trademark of Gemstar Development
Corporation. The G-Code system is manufactured under
licence from Gemstar Development Corporation.
3 Press the OK button.
Result: The information concerning the programme
is displayed.
☛
When using the G-Code function for the
first time with stored stations, the programme
number flashes. This one time, you must enter
the station number manually by pressing the
or ❷ buttons. Refer to the following page if:
Before presetting your STB-DVD-VCR:
◆ Switch on both the television and your STB-DVD-
VCR
◆ Check that the date and time are correct
◆ Insert the cassette on which the programme is to
be recorded (safety tab intact)
Up to six programmes can be preset.
1 To enter a G-Code, press the TIMER button.
Press the
or ❷ and OK or ❿ buttons to select
G-Code
Result: A message is displayed to allow you to
enter the G-Code code.
☛
If all six programmes have been set, the
message Timer is full is displayed. Refer to
page 22 if you wish to cancel a preset recording.
2 Press the numeric buttons to enter the code
opposite the programme that you wish to record in
your television magazine.
➢
If you wish to correct the G-Code code that
you are entering:
◆ Press the
➛
button until the digit to be
corrected is cleared
◆ Enter the correct digit
Standard
G-Code
Timer Method
G-Code
Code
Code : 0 - 9
Correct :