Sherwood R-772 - Manual (Page 21)

21
ENGLISH
• If any of buttons fails to operate as they should,
start from the step 1 again to enter the correct setup
code.
� Note :
• Manufacturers may use different setup codes for
the same product category. For that reason, it is
important that you check to see if the code you
have entered operates as many controls as
possible. If only a few functions operate, check to
see if another code will work with more buttons.
6.
Operate the component using the corresponding
function buttons.
4.
While "PRESET" is displayed, press the ENTER
button to store the setup code.
5.
Operate the component using the corresponding
function buttons.
6.
Repeat the above steps 1 to 5 for each of your
other components.
1.
Turn on the component you want to operate.
2.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 20 to select the setup
code mode ("CODE").
3.
While "PRESET" is displayed, search a setup
code, aiming the remote control at the remote
sensor on the component.
7.
Repeat the above steps 1 to 6 for each of your
other components.
Searching a setup code
• Each time the CURSOR UP( ▲ )/DOWN( ▼ )
buttons are pressed, the setup code is selected
one by one.
• If the selected code is correct, your component
will be turned off.
• When your component is not turned off, repeat
this step until you find one that works.
• In addition to enter a setup code using "Setup
Code Table" on page 73, it is also possible to
search through all the codes that are stored in the
library of this remote control.
• Then "OK" is displayed on the LCD screen.
• If any of buttons fails to operate as they should,
start from the step 1 again to find the correct
setup code.
R-772(A) 2007.8.16 5:21 PM 페이지 21