Sherwood R-772 - Manual (Page 59)

ENGLISH
59
When selecting the SPEAKER CONFIGURATION
1.
Press the CURSOR UP( ▲ )/DOWN( ▼ ) buttons to select the SPEAKER CONFIGURATION, then press the
ENTER button.
2.
Press the CURSOR UP( ▲ )/DOWN( ▼ ) buttons to select the desired speaker.
YES/NO: Select the desired depending on whether the
speakers are connected or not.
2CH/1CH: Select the desired depending on the number of
speakers connected to SURROUND BACK/
MULTI channels.
� Notes :
• When speakers are not set to "NO", you should set their distances from listening position and crossover
frequencies according to their frequency characteristics. (For details, refer to "When selecting the SPEAKER
DISTANCE" on page 60 and "When selecting the SPEAKER CROSSOVER" on page 61.)
• When the "SURROUND" is set to "NO", "BACK/MULTI" cannot be set to "2CH" or "1CH".
• When the surround back channels' power amplifier is assigned to "BI-AMP" or "ROOM 2", the "BACK/MULTI"
cannot be selected. (For details, refer to "When selecting the AMP ASSIGN" on page 49.)
3.
Press the CURSOR LEFT( ◀ )/ RIGHT( ▶) buttons to set the selected speaker as desired.
4.
Repeat the above steps 2 and 3 until the speakers are all set as desired.
R-772(A) 2007.8.16 5:21 PM 페이지 59