Sherwood R-772 - Manual (Page 28)

28
Changing the transmission signal
• This remote control can emit not only the infrared
beams which the conventional remote control
uses but also the RF(Radio Frequency) beams
which are stronger than those.
• When you want to control this receiver from longer
distance even if there are obstacles such as walls,
furniture, etc. in the way, change the transmission
signal into "RF"(Radio Frequency).
� Notes:
• When the RF remote antenna is not connected,
remote operation will become unreliable. (For
details, refer to "CONNECTING RF REMOTE
ANTENNA" on page 12.)
• If the transmission signal mode is set to "RF"
(Radio Frequency), this remote control cannot
control other audio and video components.
1.
Press and hold down the ENTER button and
any of the DEVICE buttons for more than 2
seconds.
• Then "LEARN" is displayed on the LCD screen for
several seconds.
� Note:
• During setting operation, to exit from the setting
mode, press any of the DEVICE buttons.
2.
While "LEARN" is displayed, press the
CURSOR UP(
▲ )/DOWN( ▼ ) buttons to select
the transmission signal mode("RF-IR"), then
press the ENTER button.
• Then "RF" (or "IR") is displayed.
• If "RF" (or "IR") goes off, start again from the
above step 1.
3.
While "RF" (or "IR") is displayed, press the
CURSOR UP(
▲ )/DOWN( ▼ ) buttons to select
the desired transmission signal, then press the
ENTER button.
4.
To pair up this remote control and the receiver,
press the CONTROL DOWN(
▼ ) button and the
MEMORY/ENTER button simultaneously on the
receiver.
5.
While "RF REMOCON PAIRING MODE" is
displayed, press the ENTER button, aiming at the
receiver.
• Each time the CURSOR UP( ▲ )/DOWN( ▼ )
buttons are pressed, the mode changes as
follows :
"RF" : This remote control emits the RF(Radio
Frequency) beams which stronger than the
infrared beams.
"IR" : This remote control emits the infrared
beams which the conventional remote
control uses.
• Then "OK" is displayed.
• "RF REMOCON PAIRING MODE" is displayed for
several seconds on the display of the receiver.
• If "RF REMOCON PAIRING MODE" goes off,
press these buttons again.
• Then "PAIRING SUCCESS" is displayed.
ENGLISH
� When "RF" is set to.
R-772(A) 2007.8.16 5:21 PM 페이지 28