Sherwood R-772 User Manual
Page 65
ENGLISH
65
Memorizing the adjusted channel levels
• You can memorize the adjusted channel levels into preset memory("REFERENCE 1", "REFERENCE 2") and
recall the memorized whenever you want.
• The "REFERENCE 1" indication flickers.
• Each time the CURSOR LEFT(
◀
) or RIGHT(
▶
)
button is pressed, "REFERENCE 1" or
"REFERENCE 2" is selected.
• The adjusted channel levels have now been
memorized into the selected memory.
• "CALIBRATE" may be displayed instead of
"REFERENCE 1" or "REFERENCE 2".
• Then the channel levels memorized into the
selected preset memory are recalled.
Recalling the memorized channel levels
1.
After performing the steps 1 ~ 3 in "Adjusting the current channel level" procedure on page 64, press the
CURSOR UP(
▲
)/DOWN(
▼
) buttons to select a channel (, not the MODE (memory mode) and the LFE
LEVEL SETUP), then press the ENTER button.
2.
Press the CURSOR LEFT(
◀
)/RIGHT(
▶
) buttons to select the desired preset memory, then press the
ENTER button.
2.
Press the CURSOR LEFT(
◀
)/RIGHT(
▶
) buttons to select the desired one of REFERENCE 1 and
REFERENCE 2.
1.
Press the CURSOR UP(
▲
)/DOWN(
▼
) buttons to select the MODE(memory mode).
R-772(A) 2007.8.16 5:21 PM 페이지 65