Sherwood R-772 User Manual

Page 35

Advertising
background image

ENGLISH

35

Continued

To cancel the surround mode for stereo operation

• Depending on the signal format which is being input, either the stereo

mode or the 2CH downmix mode is selected.

• To cancel either the stereo mode or the 2CH downmix mode, select

the surround mode with using the MULTI CONTROL knob on the
front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on
the remote control.

2CH downmix mode

• This mode allows the multi-channel signals encoded in DTS or Dolby Digital format, etc. to be mixed down into

2 front channels and to be reproduced through only two front speakers or through headphones.

• When the SPEAKER button is set to off to listen with headphones, if the STEREO button is pressed while

playing the multi-channel digital signals from DTS or Dolby Digital sources, etc., it will enter the 2CH downmix
mode automatically.

• To cancel the 2CH downmix mode, select the Dolby Headphone mode with using the MULTI CONTROL knob

on the front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on the remote control.

• The Dolby Headphone function simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel

surround sound through 2 channel headphones, just like listening from 5.1 channel speakers.

Note :

• Only when the SPEAKER button is set to off, the Dolby Headphone mode can be selected.

• Switch the speakers off to listen with headphones.

Listening in Dolby Headphone mode

• The volume level of each channel can be

adjusted easily with the test tone function.

Note : When the SPEAKER button is set to off,

the test tone function does not work.

Adjusting each channel level with test tone

• The test tone will be heard from the speaker of

each channel for 2 seconds as follows:

Front Left Center Front Right Surround Right

Subwoofer Surround Left Surround Back Surr.Back Left Surr.Back Right

When the speaker setting is "NO", the test tone of the
corresponding channel is not available.

• ( ) : Possible depending on whether the surround

back channel is set to "2 CH" or "1 CH".

• You can select the desired channel with pressing

the CONTROL UP/DOWN (

▲/▼

) buttons or the

CURSOR UP/DOWN (

▲/▼

) buttons.

1.

Enter the test tone mode.

3.

Cancel the test tone function.

2.

At each channel, adjust the level as desired until
the sound level of each speaker is heard to be
equally loud.

• Then "DOLBY HEADPHONE" (or "DOLBY H ~ ") is displayed and

the Dolby Headphone mode is selected.

• To cancel the Dolby Headphone mode, press the SPEAKER

button again.

R-772(A) 2007.8.16 5:21 PM 페이지 35

Advertising