Samsung SF 4700 - Manual (Page 28)

1.21 Getting Started
Setting the Date and Time
The current date and time are shown on the display when the machine is
on and ready for use (Standby mode). The date and time are printed on
all transmitted faxes.
When you install the SF-4700 for the first time, or when the product is
without power for about 15 seconds, the display prompts you to reset the
date and time.
1. Press Setup on the front panel. The display asks you to set the month.
2. Enter the correct date and time for each item using the number
keypad. Each time you enter the appropriate number, the display asks
you to enter the next item in the following order: MONTH, DATE,
YEAR, HOUR, MINUTE, AM/PM.
You can change the clock mode to 24 hour or 12 hour modes. See
“Setting User-Selectable System Options” on page 4.34. If the 12
hour mode is selected, AM/PM selection is not available when you set
the date and time.
If you enter an invalid number, the display does not proceed to the
next step. If this happens, re-enter the correct number.
To select a specific item to change, press Option repeatedly to find
the item. After setting, press Start/Enter to save.
3. When you are finished, the display returns to Standby mode and
shows the date and time.
Note: If you press Setup in Standby mode, and press Start/Enter, you can
also access this menu option.
SET DATE & TIME
PRESS SETUP
DATE JAN/01/2000
01 = JAN
MONTH
02=Feb
03=Mar
...
.
month setting