Sony HDS-X5800 - Manual (Page 10)

1-2 (E)
HDS-X5800
1-2. Operating Environment
w
Do not install the unit in a place subject to excessive oil
vapor, steam, moisture, or dust, otherwise a fire or electric
shock may result.
m
. To prevent the temperature rising inside the unit, ensure
there is adequate circulation of air near where the unit is
installed. Never block the ventilation holes.
. Never install the unit near a heat source.
Operating temperature : 5 dC to 40 dC
Storage temperature : _20 dC to +60 dC
Operating humidity : 10% to 90% (no condensation)
1-3. Power Supply
The HDS-X5800 contains the four power supply units as
the standard installation.
The units A1 and B1, and the units A2 and B2 back up the
two power line systems respectively. Therefore, turn on all
of the four power supply units when using the HDS-
X5800.
(Refer to Section 2-1 for the location of the power supply
units.)
1-3-1. Power Specifications
Power requirements AC 100 to 240 V
±10%
Power frequency 50/60 Hz
Current consumption AC100 V : 12 A (max.)
AC240 V : 4 A (max.)
Inrush current At power voltage of 100 V : 60 A
(Maximum when all of the four
power supply units are turned on)
At power voltage of 240 V : 85 A
(Maximum when all of the four
power supply units are turned on)
Power consumption 1200 VA (max.)
n
The capacity of the AC power must be commensurate with
the inrush current. If the capacity of the AC power is not
sufficiently large, the breaker of the AC power on the
supply side will trip or the unit will not operate normally.
1-3-2. Power Cord
w
The power cords are not supplied with the unit. Be sure to
use power cords that are suitable for the place of operation.
n
For the customer outside of the area as shown above,
please contact your local Sony Sales Office/Service
Center.
1-2. Operating Environment
1-3. Power Supply
For customers in the U.S.A. and Canada
1 Power cord, 125 V 10 A (2.4 m) : ! 1-557-377-11
2 Plug holder (Black) :
2-990-242-01
AC inlet
2 1
For customers in the United Kingdom
1 Power cord, 250 V 10 A (2.4 m) : ! 1-782-165-11
2 Plug holder (Brown) :
3-613-640-01
1 AC inlet
2
For customers in European countries except the United Kingdom
1 Power cord, 250 V 10 A (2.0 m) : ! 1-551-631-22
2 Plug holder (Brown) :
3-613-640-01
1 AC inlet 2