Sony HDS-X5800 - Manual (Page 12)

1-4 (E)
HDS-X5800
1-5. Rack Mounting
The HDS-X5800 is mounted in the 19-inch standard rack.
To mount the HDS-X5800 in the rack, use the rack mount
kit that is supplied with the HDS-X5800 and follow the
procedure described below.
n
If other than the specified rack mount kit is used, the HDS-
X5800 may not be mounted in the 19-inch standard rack.
Parts of the supplied rack mount kit
. Support angle
2 pcs
. Bracket 4 pcs
. Support angle fixing screw 8 pcs
(PSW4 x 10 : 7-682-962-01)
. Bracket fixing screw 8 pcs
(B4 x 10 : 7-682-562-04)
Other required parts
To mount in the rack, the supplied rack mount parts and
the following part are required.
. Screw for rack mounting
4 pcs
(B5 x 12 : 7-682-576-04)
1-5. Rack Mounting
1-5-1. Precautions for Rack Mounting
w
. Be sure to mount in the rack with four persons or more.
. Mount in the rack in a stable position.
. To prevent the rack from falling or moving, fix the rack
on a flat and steady floor using bolt or others.
If the rack falls due to the weight of the equipment, it
may cause death or injury.
. After rack mounting, be sure to tighten the screws on the
rack angle and fix the unit in the rack.
If the screws on the rack angle are not tightened, the unit
may slip from the rack and fall, causing injury.
c
When mounting the unit in the rack, note the following:
. Be sure to use the supplied rack mount kit.
If not, injury may result and the equipment may fall due
to insufficient strength.
. Be careful not to catch your fingers or hands in the rack
mount rail or others.
n
If several units are mounted in a rack, it is recommended to
install a ventilation fan to prevent temperature rise inside
the rack.