Sony HDS-X5800 - Manual (Page 65)

2-15 (E)
HDS-X5800
2-6-3. Uploading Data
Upload the various setup data of the system equipment is executed from primary stations to a PC.
1. Install the BZR-20 software. (Refer to Section 2-6-2.)
2. Turn on the power of all the equipment on the S-BUS data link.
3. Connect the PC to the REMOTE3 connector or the DATA (Ethernet) connector of the HDS-X5800
(or connect the PC to each equipment). (Refer to Section 2-6-1.)
4. Turn on the power of the PC.
5. Start up the BZR-20 software by clicking the BZR-20 icon. The following menu appears.
6. Select a desired folder (any folder in the hard disk or FD drive) in which the uploaded setup data are
saved, from the File (F) menu of the menu bar. Press [OK].
n
You cannot create a new folder at this step.
7. Select the desired button from “RECEIVE: PRIMARY to PC” column that suits to the contents of the
uploaded data and press the button.
[DescriptionF1] : It uploads the names of the total 2048 connectors of the SOURCE (input) and
DESTINATION (output) that are assigned to the primary station.
[CrosspointF2] : It uploads the latest cross-point data (1024 sources and 1024 destinations, level:
8) that are saved in the primary station.
[PrimaryF3] :
It uploads the setup data that are saved in the primary station.
(The data as the secondary station that are stored in the primary station are
uploaded at the same time.)
n
When uploading the setup data that are stored in the primary station, name of the
connecter and the cross-point data are not included.
[SecondaryF4] : It uploads the setup data of the equipment that is connected to the S-BUS remote.
Press Cancel (C) to stop uploading.
8. When uploading is completed, press Exit (E) and close the BZR-20 window.
Set up the
communication port.
Uploading the data
(Section 2-6-3)
Select a folder in which the uploaded or
downloaded setup data are saved.
Simplified description of operation manual
Downloading the data
(Section 2-6-4)
2-6. Data Backup