Sony HDS-X5800 - Manual (Page 24)

1-16 (E)
HDS-X5800
Precautions for connection
. For the routing switcher that is used as the primary station, set the S/P selector switch on the CPU board
to the “P” position.
. For the routing switcher that is used as the secondary station, set the M/S switch on the CPU board (S/P
selector switch in the HDS-X5800) to the “S” position.
. A primary station can control up to 253 secondary stations.
. A single S-BUS line can be connected to up to 128 secondary stations.
. The maximum length of a single S-BUS line cable is 500 m (when the BELDEN 8281 cable is used).
. Terminate the T-type bridge that is connected to the last machine of the S-BUS line with a 75 Z
terminator. Also, terminate the unused REMOTE1 connector of each switcher with a 75 Z terminator.
. Among the REMOTE1 connectors of the secondary routing switcher, two or more REMOTE1
connectors can be used.
How to use the T-type bridge
The B type of T-type bridge is supplied with the HDS-X5800. Prepare coaxial cable (BELDEN 8281) of 50
cm or less and use the T-type bridge as follows.
1-10. How to Extend Inputs and Outputs
1-10-1. Equipment Required for System Extension
The HDS-X5800 can process the 1024 inputs x 1024 outputs at the maximum.
Number of matrix inputs and outputs can be increased by connecting the following equipment.
The HDS-X5800 configuration can be flexibly extended in accordance with the required number of
matrix inputs and outputs. Model names and quantity of the required equipment for the typical matrix
sizes are shown below.
For extending the system to the matrix sizes other than the followings, find out the model names and
calculate the quantity that are required for the desired system extension using the following equations.
REMOTE1
(BNC-type connector, male)
HDS-X5800
(rear panel block)
BELDEN 8281 coaxial cable
(50 cm or less)
T-type bridge (B)
1-9. System Connection
1-10. How to Extend Inputs and Outputs