Sony HDS-X5800 - Manual (Page 27)

1-19 (E)
HDS-X5800
1-10-3. Cascade Connection Example
In order to extend the input, the optional 34 cascade input board set (HKS-5811M or HKS-5811SD)
should be installed in the HDS-X5800. Up to eight sets of the 34 cascade input board set can be installed
in a single HDS-X5800.
Procedure
1.
Install the HKS-5811M or the HKS-5811SD in the HDS-X5800.
n
Connect the EQ-91 board to the MX-103 board or connect the EQ-92 board to the MX-104 board.
Install the CI-29 boards in the CASCADE IN slot. (Refer to “1-6. Installation of Optional Boards”.)
2. Connect the cascade input cables as shown in the following illustration.
According to the numbers that are attached to the cables, connect the 1st cable to the OUT1 connector
and connect the 2nd cable to the OUT2 connector. Also, connect the 1st cable of the CH18-34 of the
CASCADE IN slot to the OUT18 connector and connect the 2nd cable to the OUT19 connector.
3. Establish the various setups referring to Section 1-10-6.
Connection
1-10. How to Extend Inputs and Outputs
OUT1-8
OUT9-17
OUT
18-25
OUT
26-34
CASCADE IN
1-34
CASCADE IN
35-272
Input 265-528 Input 1-264
Output 1
Output 272