Sony HDS-X5800 - Manual (Page 29)

1-21 (E)
HDS-X5800
1-10-5. Input/Output Extension Example
In order to extend both of the input and output, combination of the input extension and the output exten-
sion that are described before are used.
Procedure
1.
Install the HKS-5811M or the HKS-5811SD in the HDS-X5800.
n
Connect the EQ-91 board to the MX-103 board or connect the EQ-92 board to the MX-104 board.
Install the CI-29 boards in the CASCADE IN slot. (Refer to “1-6. Installation of Optional Boards”.)
2. Connect the cascade input cables as shown in the following illustration.
According to the numbers that are attached to the cables, connect the 1st cable to the OUT1 connector
and connect the 2nd cable to the OUT2 connector. Also, connect the 1st cable of the CH18-34 of the
CASCADE IN slot to the OUT18 connector and connect the 2nd cable to the OUT19 connector.
3. Connect the signal processing unit PFV-SP3300 with the signal distribution board HKPF-SP003 to
the HDS-X5800 as shown in the following illustration. Connect them in accordance with the number
of outputs to be extended.
Connection
1-10. How to Extend Inputs and Outputs
OUTPUT 1-272
OUTPUT 273-544
Input 265-528 Input 1-264
CASCADE
CASCADE
PFV-SP3300 (HKPF-SP003 17 pcs are installed) 15 units
(HKPF-SP003 9 pcs are installed) 1 unit
PFV-SP3300 (HKPF-SP003 17 pcs are installed) 15 units
(HKPF-SP003 9 pcs are installed) 1 unit