SMC Networks SMC9432BTX - Manual (Page 28)

3-4
I
NSTALLING AND
C
ONFIGURING
N
ETWORK
D
RIVERS
Windows NT 4.0 Installation
First-time installation
If you've already installed a network card, configured Windows NT
Networking, or configured a network driver, refer to the procedure
titled “Secondary Installation.”
1. If Windows NT is already installed on your computer, proceed
to Step 2. Otherwise, complete a first-time Windows NT
installation without the SMC network card installed.
2. Shut down your PC, install the SMC network card, and attach
the network cable. Restart Windows NT.
3. Double-click on the “My Computer,” “Control Panel,” and
“Network” icons. The “Network Configuration” window
appears, prompting you to install Windows NT Networking.
Select “Yes.” Windows NT invokes the “Network Setup
Wizard.” Click on “Next.”
4. When prompted to “Search for a Network Adapter,” click on
“Select from List.”
5. When prompted to “Select a Network Adapter,” click on “Have
Disk.” Insert the SuperDisk when prompted and click on “OK.”
6. You are presented with the “Select OEM Option” window.
Highlight “EtherPower II 10/100” and click on “OK.”
7. When prompted to “Search for an Adapter,” click on “Next.”
8. Select network protocols when prompted and click “Next.”
Note: To complete a TCP/IP installation, you will need to know
your IP Address and Subnet Mask. For further information,
contact your network administrator or Internet service
provider.