1 processing cable end – Sharp JW-20CM User Manual

Page 25

Advertising
background image

6

·

2

6-1 Processing cable end

Applicable cable

High frequency coaxial cable: ME-5C-2V

Required tools

Stripper for high frequency coaxial cable: CST-TM

Processing procedure

Blade cassette

Cam wheel

Rear

Blade (slashed area)

Within 1 mm

Slider

Blade setting gauge

Set the operation range of the cable holder by moving
the slider at the bottom of the body. Move to the left
to increase pressure.
In this example, set the slider to the cam wheel side’s
end (right side) to set the pressure to low.

Adjust the cutting depth of the blade by turning the
two screws at both ends of the screw holder. Set
the blade position to within 1 mm from the cutting
surface of the blade cassette prior to adjusting the
cutting depth. For the cutting depth adjustment, use
the “blade setting gauge” supplied as an accessory
and match the blade position with the caved position
of the gauge. Then move the cam wheel forward
and secure firmly. Turn right lightly both adjustment
screws at either end of the screw holder for
adjustment. (Be careful not to break the blade setting
gauge as it is made of aluminum.)

(Fine adjustment is required to get the
optimum cutting depth.)

Move the cam wheel of the stripper (amber colored
ring) back and forth and the cable holder moves back
and forth accordingly. Confirm this movement of the
stripper first.
To hold the stripper, put your forefinger through the
hole and move the cam while pushing back and forth
with your thumb.

<Basic operation>

<Pressure setting>

<Adjustment of blade cutting depth>

To the next page

Screw holder

Right

Left

Cam wheel

Front

Cable holder

Set the blade to within

1 mm in order not to

damage the blade by

the blade setting gauge.

Advertising
This manual is related to the following products: