3 outine of switch and parameter setting procedure, Remarks – Sharp JW-20CM User Manual

Page 46

Advertising
background image

8

·

8

8-3

Outline of switch and parameter setting procedure

In brackets: See page

Start

Power “OFF” master/slave station

Set switch of master module

Set switch of slave module

Set parameter of slave module

Set parameter of master module

End

[8·9]

[8·14]

[8·19]

[8·30]

· Make sure to turn “OFF” the power of the PC prior to setting the switch.

· Parameter must be started from the slave module first.

· Prior to setting the parameters of master module, set the operation mode of the JW-20CM

to “program mode.”

· Make sure to write the set parameters into the EEPROM on the JW-20CM after setting.

Remarks

Advertising
This manual is related to the following products: