King Controls KD-2200 - Manual (Page 10)

Page 8
EXTERNAL WIRING
9. Plug external wire harness into wiring port on back of dome unit and tighten connection until
it clicks past the detent lock (Fig. 8).
10. Fill end of coax cable that will connect to the MAIN port on the dome unit with supplied
dielectric grease. Connect this end of the coax cable to the MAIN port and tighten
connection (Fig. 8).
If using a second (auxiliary) receiver, fill end of second coax cable (not supplied) and connect
it to the AUX port. Tighten connection.
DO NOT OVER TIGHTEN CONNECTIONS.
Note: The King-Dome AIR is wired for multiple receiver support. There are two coax ports on the back of the dome unit.
The one labeled “MAIN” MUST be connected thru the diplexer to the main receiver in vehicle. This is the
receiver that will control automatic satellite switching if applicable. The one labeled “AUX” can be used for an
additional receiver.
IMPORTANT! You must fill the ends of all external coax cables with the supplied dielectric grease.
Failure to do so will void product warranty.
Fig. 8
IMPORTANT!
Fill ends of coax cables with supplied dielectric grease.
Failure to do so will void product warranty.
Coax connections should be snug. DO NOT OVER TIGHTEN!
IMPORTANT!
The alignment tabs on the
wiring port and the external
wire harness plug must
match up when engaging
plug onto port.
YOU MUST TIGHTEN THE
EXTERNAL WIRE HARNESS
PLUG UNTIL IT CLICKS
PAST THE
DETENT LOCK.
(A channel lock pliers may
be used to tighten the
connection.)